Filter
Top Products
Dial operation from station No. 200.
— Initial programming of the exchange —
Dial the Following:
Dial tone will be heard (Station No.200 becomes a programming station)
1.
2.
3.
4.
5.
6.
Confirmation tone will be heard.
(Clears function group A)
Confirmation tone will be heard.
(Clears function group B)
Confirmation tone will be heard
(Clears function group C)
Confirmation tone will be heard.
(Clears function group D)
Confirmation tone will be heard.
(Clears personal numbers and single digit dial numbers)
Program necessary functions
(Refer to separate instructions for each function)
Remark: If there is any error in CMOS memory, you hear calling tone instead of confirmation tone.
Place program switch on front panel of the CPU in "OFF" position.
Dial operation from station No. 200.
(Station No. 200 becomes a normal station.)
Note 1. When the exchanges are connected by tielines, perform this
operation in the CPU-56 unit of all exchanges.
Note 2. The programming station of each exchange is as follows:
No. 200 (exchange "A")
No. 470 (exchange "B")
No. 740 (exchange "C")
10 times
10 times
10 times
10 times
10 times
– 15 –