Filter
Top Products
3
Power Supply
Quick Setup Guide
Connecting the Printer
Note: The power supply must be connected into the back of the printer before
connecting the communication cables.
1. The Power Adapter has a barrel connector on one end that must be inserted
into the power jack on the back of the printer.
2. Plug the other end of the cord into an appropriate 120V AC electrical outlet.
Parallel Interface Requirements
Note: This printer complies with FCC “Rules and Regulations”, Part 15, for
Class B Equipment, using fully shielded six-foot data cables. Use of longer
cables or unshielded cables may increase radiated emissions above the
Class B limits.
The included cable (IEE 1284-compliant) has a standard 36-pin parallel connector
on one end, which is plugged into the parallel port located on the back of the
printer. The other end of the parallel interface cable connects to the parallel port
on the host computer.
Data cables must be of fully shielded construction and fitted with metal or
metalized connector shells. Shielded cables and connectors are required to
prevent radiation and reception of electrical noise.
To minimize electric noise pickup in the cable:
1. Keep data cables as short as possible (6 feet recommended).
2. Do not tightly bundle the data cables with power cords.
3. Do not tie the data cables to power wire conduits.