Filter
Top Products
WiebeTech LLC
Chapter 3 GUI Connection
3.1 GUI – http
ProSATA SS8 supports graphic user interface (GUI) to manage the system by any web
browser. Be sure to connect LAN cable to the network. The ProSATA will automatically
obtain an IP address if connected to a network that has DHCP support. Check the
ProSATA’s LCD for this address (found on the bottom side of the unit). The GUI can be
accessed by typing the IP address in the browser URL address bar, as follows:
http://192.168.0.200
If DHCP is not available on your network then manual configuration will be required. If
connecting directly from the ProSATA to your computer then you will need a cross-over
cable. You'll then need to set the IP of the ProSATA to something similar to the IP
address of your computer: YYY.YYY.YYY.XXX (Ys being the same numbers as your
computer's IP). More info on manually setting an IP address is found in section 4.4.1.
Upon clicking on any function for the first time, a dialog window will pop up to
authenticate login name and password.
Login name: admin
Default password: 1234
3.2 RS-232 serial port
Use RS-232 serial cable to connect console port.
Default baud rate: 115200, 8 bits, 1 stop bit, and no parity.
Terminal type: vt100
Login name: admin
Default password: 1234
3.3 Remote control – secure shell
SSH (secure shell) is required for ProSATA SS8 to remote login. The SSH client
software is available at the following web site:
SSHWinClient:
http://www.ssh.com
Putty:
http://www.chiark.greenend.org.uk
Host name: 192.168.0.200
Login name: admin
Default password: 1234
Note
Using ssh, the IP address has to be setup and the password is
required for login.
ProSATA SS8 User Manual - 10 -