Filter
Top Products
B-5
Changing a Relay back to a Base
You can convert the Relay back to a Base Station by setting any of the
422 Termination jumpers to the Base position. You can check the
outcome by simply powering up the unit - a Base blinks green; a Relay
blinks yellow.
Changing the Channel on a Relay
The Relay must have their channel set to the same channel as the R/F
Terminals in their network. The channel is set on a Relay by turning a
rotary switch to the setting 0-9 (10 Channels in the US.) or 0-5 (6
Channels in Europe). Use a very small flat head screwdriver to turn
the switch to the desired number.
Setting the Relay ID
If you only have one relay, there is no need to set the Relay ID which is
shipped default as relay 1. If you need to change it or you have multiple
relays, it must be changed using the RF 700 Base Serial Configuration
Utility.
RS-422 Termination
When adding Relays to a system, the last Relay(s) in the line(s) must be
terminated. By default, all Base stations are shipped as terminated. Use