Filter
Top Products
Advanced Section
M370078-06 2-31
Figure 2-34 shows the HyperTerminal session for the combined
configuration which is an ENET and RS-485 network. This figure also
shows access to power supplies #2 and #10 sequentially.
Setting Up Your System
To set up your system:
1. Connect your system as shown in Figure 2-33, and turn every power
supply unit to ON.
2. Set up your computer as described in “Setting Up the Computer” on
page 2–6. Repeat this section for each computer hooked up to the
system.
3. Install the DeviceInstaller software on the PC you wish to use to
configure the XG unit (s) with. See the instructions for “Software
Installations” on page 2–9.
4. Configure the ENET card of the master XG (power supply #1 in
Figure 2-33). See the instructions for “Configuring the Device Using
DeviceInstaller” on page 2–11.
Figure 2-34
HyperTerminal Window