Filter
Top Products
For more information on Genuine Xerox Supplies, call 1-800-822-2200 in the USA and 1800-668-0133 in Canada 8
− GBC Hi-Tac or Transilwrap Spartan film, nylon for both
− The laminator should be run at the slowest speed possible, 15 feet per minute is usually the
maximum depending on the output being laminated
− The actual roll interface temperature is to be @ 260-265°F.
− The tension on the film during laminating should be at the lowest possible setting
− Increasing the amount of time between printing and laminating normally increases the adhesion of
the film to the paper
Two Sided Lamination
− Polyester material provides better scuff resistance
− GBC two sided roll type laminators
Note: Shoe type laminators have not demonstrated satisfactory performance for either single or
double sided laminating of DocuColor 2045 / 2060 / 5252 output.
Carbonless Papers
Carbonless papers are pressure sensitive papers that are coated with several functional coatings.
These coatings promote image transfer through the form set and enable the form sets to separate
appropriately after padding with a special adhesive. Xerox has enabled this application on DocuColor
2045 / 2060 / 5252 by combining a unique paper coating chemistry (Xerox Premium Digital
Carbonless), with a software “switch” designed to disable key machine components reducing the
frequency of service calls. Since each supplier of xerographic carbonless papers has developed their
own chemistry, the following procedure does not enable any other carbonless product.
• Contact your local service representative to ensure machine software has been upgraded to V
6.27 (DC2045, DC2060) or V 7.1.2 (DC5252) or later.
• Enter machine “tools” mode (Refer to System Administration Guide for more information)
• Touch “Machine Defaults 3” tab on the machine User Interface (UI)
• Enter Chain Link 700-656 on the UI key pad (hyphen will be added automatically)
• Press “Start” to display “Current Value”. “0” (on) will be displayed.
• Touch “1” on the UI key pad. “1” (off) appears in “New Value” box.
• Touch “Close” and then “Exit Tools” on the UI touch screen
Note: This procedure must be performed at the start and end of each Xerox Premium Digital
Carbonless Paper run. Failure to do so will lead to premature component failure.
As this machine is equipped with a friction feed device, the sheet sustains a small scuff mark visible
on the CF and CFB sheets as it is fed from the trays.