Filter
Top Products
POWERING ON AND OFF
8 XES SYNERGIX 8850 PRINTER OPERATOR MANUAL
Powering off
To power off:
1. Switch the circuit breaker to the Off (O) position. This turns off
power to the AccXES controller. The AccXES controller does
not have a separate power switch.
2. Switch the printer power switch to the Off (O) position. This
turns off power to the printer.
Power consumption modes
The printer has four power consumption modes. They are:
Running
The printer is capable of making prints immediately in this mode.
When in this mode, the message display indicates that the printer
is "PRINTING."
Ready
The printer enters this mode 2 to 30 seconds after completion of a
print. When in this mode, the message display indicates that the
printer is "IDLE."
Power saver
The printer enters this mode to reduce energy consumption after a
specified period of inactivity since the completion of the last print.
This time period is user-programmable. The range is 5 to 50
minutes. See the "Off-line Setup Menu" chapter for more
information about setting the power saver timer.
NOTE: When the printer is in this mode, the fuser is at low power.
The printer needs to warm up from an L3 status code before being
ready to print.
Rest
The printer enters this mode to minimize energy consumption after
a specified period of inactivity since entering power saver mode.
This time period is user-programmable. The range is 15 to 150
minutes. See the "Off-line Setup Menu" chapter for more
information about setting the rest mode timer.
NOTE: When the printer is in this mode, the fuser is off. The
printer needs to warm up from an L9 status code before being
ready to print.