Filter
Top Products
PROBLEM SOLVING
XES SYNERGIX 8850 PRINTER OPERATOR MANUAL 43
Error messages
The error messages shown in the table below may appear on the
message display. Follow the instructions in the table before calling
for service.
Table 3. Error message table
Error Message Problem Solution
CHECK FOLDER
FOLDER COMMUNICATIONS ERROR #17
FINISHER CONFIG TYPE
enabled, but no folder is
installed.
1. Press the On-line/Off-line
key to take the printer off-
line.
2. Reset the value to NONE.
Refer to "Specifying the
finisher configuration
type" in this manual for
instructions.
F2-01 CHECK FOLDER
FOLDER COMMUNICATOINS ERROR #01
FINISHER CONFIG TYPE
enabled, but no folder is
installed.
1. Switch the printer Off.
2. Wait five seconds. Then
switch the printer On.
3. As soon as the Printer
Firmware Version
message is displayed,
press the On-line/Offline
key to take the printer off-
line.
4. Reset the value to NONE.
Refer to "Specifying the
finisher configuration
type" in this manual for
instructions.