Filter
Top Products
GETTING TO KNOW YOUR DOCUCOLOR 12 2–4 DOCUCOLOR 12 USER GUIDE
2
3
4
5
6
7
2
4 Low Power button - Press this button to initiate
the Low Power mode. The DocuColor 12 will also
go into Low Power mode automatically if it is not
used for a length of time specified by the System
Administrator in the Tools Mode.
The Low Power mode enables the DocuColor 12
to use less power than when it is in Ready mode.
Press the Low Power button again to bring the
copier/printer into a warm-up cycle.
5 Interrupt - Press this button to stop the copier/
printer during the copy process. The copier/printer
completes the in-progress copy job. Once the
copy job is completed, interrupt occurs and the
interrupt job may be started. There are two
indications the job has been interrupted:
• The copier/printer displays a message
indicating that Job Interrupt has been
selected, and it is ready to copy.
• The indicator light flashes to acknowledge that
the Interrupt button has been pressed. It
continues to flash until the copier/printer
interrupts the job in process. When the
Interrupt indicator light is on continuously (not
flashing), a new job can be programmed.
After all interrupting jobs have been completed,
press the Interrupt button again to exit the
Interrupt mode and return to the first job.
NOTE: Interrupt should not be used when the
machine is in a fault condition (except for Image
Quality faults, alerts, or when a message indicates
the job is incomplete) or with the following types of
jobs:
• Repeat Image
• Multiple-Up
Interrupt should also not be used when you are
using the Stored Jobs feature or when you are on
the Auditron Access screen or in Tools mode.