Filter
Top Products
PhaserShare Networking Manual
15
PhaserShare Series B Network Interfaces
2
Ring speed jumper
The Token Ring card is equipped with a single three-pin jumper to set the ring speed.
There are two settings: 4 Mbps and 16 Mbps.
N
O
T
E
If you received your printer with the Token Ring card already installed, you must turn
off the printer and remove the card before you change the jumper setting.
The following illustration shows a top view of the card and the location of the
jumper.
1.
Rear panel
2.
Jumper
9789-03
16 Mbps 4 Mbps
2
1