Filter
Top Products
PhaserShare Networking Manual
69
TCP/IP Printer Configuration (All Platforms)
7
Enabling and disabling RARP and BOOTP/DHCP (front panel)
RARP, BOOTP, and DHCP can be enabled and disabled from the front panel. The
default is enabled. When you set the IP addressing parameters from the front panel,
the front panel selections for DHCP/BOOTP and RARP are automatically set to
Disabled. To disable these protocols manually, follow the procedure for your printer:
■ “Phaser 740 and 360 printers” (the next topic).
■ “Phaser 780 printer” on page 70.
Phaser 740 and 360 printers
1.
Press Menu; the front panel displays Help Pages.
2.
Press ----> or <---- until the front panel displays Network Settings.
3.
Press Menu until the front panel displays TCP/IP.
4.
Press Menu again; the front panel displays Interface.
5.
To disable DHCP/BOOTP:
a.
Press ----> until the front panel displays DHCP/BOOTP.
b.
Press Menu again to display the current status of the protocol:
Interface:Enabled or Interface:Disabled. The current status
is marked with an asterisk (*) in the upper-right corner of the display.
c.
Press ----> until the front panel displays Interface:Disabled.
d.
Press OK to disable the protocol; the front panel briefly displays
Selected, then it displays Interface.
e.
Press Exit (the far left button) to return to the Interface display.
6.
To disable RARP:
a.
Press ----> until the front panel displays RARP.
b.
Press Menu again to display the current status of the protocol:
Interface:Enabled or Interface:Disabled. The current status
is marked with an asterisk (*) in the upper-right corner of the display.
c.
Press ----> until the front panel displays Interface:Disabled.
d.
Press OK to disable the protocol; the front panel briefly displays
Selected, then it displays Interface.
e.
Press Exit (the far left button) to return to the Interface display.