Filter
Top Products
PhaserShare Networking Manual
63
TCP/IP Printer Configuration (All Platforms)
7
Setting IP parameters: Phaser 360 printer front panel
N
O
T
E
When you set the IP addressing parameters from the front panel, the front panel
selections for DHCP/BOOTP and RARP are automatically set to Disabled.
1.
Press the Menu; the front panel displays Help Pages.
2.
Press ----> or <---- until the front panel displays Network Settings.
3.
Press Menu until the front panel displays TCP/IP.
4.
To set the IP address:
a.
Press Menu again; the front panel displays Enable Interface.
b.
Press ----> until the front panel displays TCP/IP Address.
c.
To display the IP address, press Menu. For example:
d.
To set the left-most digit of the address, press Increment.
e.
To advance to the next digit, press Shift. To set this digit, press
Increment.
f.
To set the remaining digits, press Shift and Increment as described
in Step e.
g.
When the address is correctly set, enter your settings into the printer by
pressing Select; the front panel displays:
h.
Press Confirm; the front panel briefly displays Selected, then
displays the IP address again. The IP address is now set in the printer.
i.
To return to the menu of IP addressing parameters, press Exit.
N
O
T
E
When you are in the menu, if the front panel is not used for 5 minutes, the
printer returns to
Ready.
000.000.000.000
Increment Shift Select
N
O
T
E
Setting the IP address to 000.000.000.000 causes the printer to use Dynamic
Address Resolution to set its IP address (see “Setting IP parameters: RARP or
BOOTP” on page 65).
Confirm Selection
Confirm
N
O
T
E
When you press Confirm to set the IP address, the printer resets the network mask
and broadcast address to the printer’s defaults; see “Printer defaults for network
mask and broadcast address” on page 57.