Filter
Top Products
52 P330i User’s Manual 980459-001 Rev. A
Smart Card Contact Station
Smart Card Contact Station Interface
Smart Card Contact Station Interface
When a command to the printer interface sends a card to the Smart Card Contact Station, the
printer connects the Smart Card Contact Station to the female DB-9 connector on the rear of
the printer.
An attached external Smart Card Programmer can be used to program Smart Card chips. The
following table shows the Smart Card Contact Points.
DB-9 Pin Smart Card Contact Points DB-9 Pin Smart Card Contact Points
1
C1 (VCC) 6 C6 (Vpp)
2
C2 (Reset) 7 C7 (I/O)
3
C3 (Clock) 8 C8 (RFU)
4
C4 (RFU)
9 (GND when chip is at station)
5
C5 (GND)
DB-9 Connector location for
Smart Card Contact Station