Filter
Top Products
Prestige 100 and 100IH ISDN Router and Router/Hub
4-8 Remote Node Configuration
Table 4-3 Remote Node PPP Options Menu Fields
Field Description Option
Standard
PPP
Encapsulation Select the CISCO PPP only when this remote node
is a Cisco machine; otherwise, select the Standard
PPP.
CISCO
PPP
Compression Turn on/off Stac Compression. The default for this
field is Off.
On/Off
(Default =
Off)
Multiple Link Options:
BOD Calculation Select the direction of the traffic you wish to use in
determining when to add or subtract a link. The
default for this field is Transmit or Receive.
Default =
Transmit or
Receive
Base Trans Rate Select the base data transfer rate for this remote
node in Kbps. There are two choices for this field-
64 where only one channel is used or 128 where
two channels are used as soon as a packet triggers
a call
64/128
Max Trans Rate Enter the maximum data transfer rate allowed for
this remote node. This parameter is in kilobits per
second. There are two choices for this field- same
as above.
64/128
Target Utility (Kbps) Enter the two thresholds separated by a [-] for
subtracting and adding the second port.
Default=10-
20
Add Persist This parameter specifies the number of seconds
where traffic is above the adding threshold before
the Prestige will bring up the second link.
Default = 5
sec
Subtract Persist This parameter specifies the number of seconds
where traffic is below the subtraction threshold
before your Prestige drops the second link.
Default = 5
sec
Once you have completed filling in Menu 11.2 – Remote Node PPP Options, press [Enter] at the
message [Press ENTER to Confirm…] to save your configuration, or press [Esc] at any time to
cancel.