Filter
Top Products
Prestige 100 and 100IH ISDN Router and Router/Hub
Remote Node Configuration 4-9
4.1.6 Remote Node Filter
Use Menu 11.5 – Remote Node Filter to specify the filter set(s) to apply to the incoming and
outgoing traffic between this remote node and the Prestige and to prevent certain packets from
triggering calls. You can specify up to 4 filter sets separated by comma, e.g., 1, 5, 9, 12, in each
filter field. The default is no filters.
Note that spaces are accepted in this field. For more information on defining the filters, see
Chapter 8. The Prestige comes with a prepackaged filter set, NetBIOS_WAN, that blocks
NetBIOS packets (call protocol filter = 1). You can include this in the call filter sets if you wish
to prevent NetBIOS packets from triggering calls to a remote node.
Figure 4-4 Menu 11.5 – Remote Node Filter
Menu 11.5 - Remote Node Filter
Input Filter Sets:
protocol filters=
device filters=
Output Filter Sets:
protocol filters=
device filters=
Call Filter Sets:
protocol filters= 1
device filters=