Filter
Top Products
Prestige 100 and 100IH ISDN Router and Router/Hub
6-4 Dial-In Server Configuration
6.3 Default Dial-In Setup
This section covers the default dial-in parameters. The parameters in Menu 13 affect incoming
calls from both remote dial-in users, and remote nodes until authentication is completed. Once
authentication is completed and if it matches a remote node, your Prestige will use parameters
from that particular remote node.
Figure 6-3 Menu 13 – Default Dial-in Setup
From the Main Menu, enter 13 to go to Menu 13 – Default Dial-in Setup. This section
describes how to configure the protocol-independent fields in this menu. For the protocol-
dependent fields, refer to the appropriate chapters.
The table below describes and contains information on how to configure each parameter in
Menu 13 – Default Dial-in Setup.
Menu 13 - Default Dial-in Setup
Telco Options:
CLID Authen= None
PPP Options:
Recv Authen= CHAP/PAP
Compression= Yes
Mutual Authen= No
PAP Login= N/A
PAP Password= N/A
Multiple Link Options:
Max Trans Rate= 128
Callback Budget Management:
Allocated Budget(min)=
Period(hr)=
IP Address Supplied By:
Dial-in User= Yes
IP Pool= No
IP Start Addr= N/A
IP Count(1,2)= N/A
Session Options:
Edit Filter Sets= No
Press ENTER to CONFIRM or ESC to CANCEL:
Press Space Bar to Toggle.