ZyAIR B-5000 Quick Installation Guide
18
5 Troubleshooting
Table 4 Troubleshooting
PROBLEM CORRECTIVE ACTION
The POWER and/or
ACTIVE LED are
off on the inline
power injector.
Make sure the power cord is connected into an adequate power supply and that the
power supply is turned on.
Disconnect and Connect the ZyAIR to the power supply. If the error persists, you may
have a hardware problem. In this case, you should contact your vendor.
The ACTIVE LED
on the inline power
injector is off.
Check the cable connection to the ZyAIR special Ethernet port.
Make sure your computer’s network card is working properly.
I cannot ping any
computer on the
LAN.
If all of the inline power injector LEDs are off, check the cables between the ZyAIR
and your computer or hub.
I cannot access the
Internet.
Make sure the ZyAIR is connected to the network.
Make sure you entered your username correctly. A username may be case-sensitive.