Filter
Top Products
Chapter 4 The Web Configurator
GS1910/XGS1910 Series User’s Guide
31
MLD Snooping This link takes you to a screen where you can view MLD snooping status, MLD group
information and SFM (Source-Filtered Multicast) information..
LLDP
Neighbours This link takes you to a screen where you can view the LLDP neighboring device
information.
LLDP-MED
Neighbours
This link takes you to a screen where you can view the LLDP-MED neighboring device
information.
EEE This link takes you to a screen where you can view the EEE information exchanged via
LLDP.
Port Statistics This link takes you to a screen where you can view LLDP traffic statistics on the Switch or
on a port.
MAC Table This link takes you to a screen where you can view the MAC address and VLAN ID of a
device attached to a port. You can also view what kind of MAC address it is.
VLANs
VLAN
Membership
This link takes you to a screen where you can view status of the VLAN group.
VLAN Port This link takes you to a screen where you can view detailed VLAN settings on a port.
Stack This link takes you to a screen where you can see whether stacking is enabled on the
Switch.
VCL
MAC-based
VLAN
This link takes you to a screen where you can view the MAC-based VLAN settings.
sFlow
sFlow Statistics This link takes you to a screen where you can view sFlow receiver state and sFlow packet
statistics on each port.
Diagnostic
Ping This link takes you to a screen where you can ping IPv4 addresses to test connections.
Ping6 This link takes you to a screen where you can ping IPv6 addresses to test connections.
VeriPHY This link takes you to a screen where you can perform a physical wire-pair test of the
Ethernet connections on the specified port(s).
VeriPHY® cable diagnostics provide extensive network cable information such as cable
length, termination status, and open/short fault location.
Maintenance
Restart Device This link takes you to a screen where you can reboot the system without turning the
power off.
Factory Defaults This link takes you to a screen where you can to reset the Switch back to the factory
defaults.
Software
Upload This link takes you to a screen where you can upload firmware to the Switch.
Image Select This link takes you to a screen where you can switch to use a second firmware image if
available.
This screen is not available on the XGS1910-24 or XGS1910-48.
Configuration
Backup This link takes you to a screen where you can back up your current Switch configuration
to a computer.
Upload This link takes you to a screen where you can restore a previously saved configuration
from your computer to the Switch.
Table 4 Navigation Panel Links (continued)
LINK DESCRIPTION