Filter
Top Products
IDP Support Notes
25
crash?
ZyWall IDP 10 does not support hardware bypass, so if your ZyWALL IDP 10 lost
power or crashed, you will need to either replace it or take it off the network
immediately.
If I forget IDP’s password, how to reset the password to default?
The default IDP user name/password is “admin/1234”. Customers can modify the
default user name/password for security reason. But sometimes users may forget their
user name/password, when this happens, please follow these steps to reset
configuration on the device.
Connect IDP device through console.
Go to debug mode, issue reset command to reset all settings (not including default
policies and user defined policies).
Reboot the device by reboot command.
ZyXEL system kernel loader v1.0.0.0 2004/04/02 (ZyXEL)
Press ENTER to enter Debug Mode
Enter DEBUG Mode
.....
Loading Kernel Image <DBGBOOT>
............................
Checksum is valid.
Starting address is at 0x100000
Kernel image load completed.
Starting kernel...
ZyXEL -- DebugKernel Version 1.0.2 (2004/04/29)
$>resetAll
Are you sure to reset all settings to manufacturing defaults? (y/n)y
Reset to defaults OK. Please reboot to apply new change.
$>reboot
Press Enter
How to access IDP through console?
To access the IDP via console port, a computer equipped with communication
software such as HyperTerminal must be configured with the following parameters.
VT100 terminal emulation
All contents copyright (c) 2004 ZyXEL Communications Corporation.