Filter
Top Products
IDP Support Notes
6
Setup IP address of IDP (A, B, C, D, E, F)
1. Configure each IDP device’s IP address.
Since IDP is a bridge device, it only has one IP address for management purpose, IDP also uses
this IP address to update signatures and the send system logs through syslog/E-mail/FTP. To
configure the system IP address of IDP device, users can choose two methods,
- Through Console
1. Make sure the baud rate/data/parity/stop/flow control settings are as below.
2. Default Login/password is “admin/1234”
3. Issue the following commands on IDP (A)
$>set system ip 192.168.1.141
Change ZyWALL IDP 10 IP address OK.
$>set system mask 255.255.255.0
Change ZyWALL IDP 10 netmask OK.
$>set system gateway 192.168.1.254
Change ZyWALL IDP 10 default gateway OK.
$>set system dns 168.95.1.1
Change ZyWALL IDP 10 default DNS server OK.
4. Repeat the step 3 to configure IDP (B, C, D, E, F) according to IP address assignment table.
- Through WEB GUI or Telnet
All contents copyright (c) 2004 ZyXEL Communications Corporation.