Filter
Top Products
Chapter 32 Introducing the Commands
VES-1616F-3x Series User’s Guide
233
32.11.4 interface Commands
The following table lists the interface port-channel commands in configuration mode.
Use these commands to configure the ports.
vlan-stacking Enables VLAN stacking on the
device.
13
<SPTPID> Sets the service provider’s TP
(Tagged Protocol) ID.
13
vlan-type <802.1q|port-based> Specifies the VLAN type. 13
wfq Sets the switch to use Weight
Fair Queuing (WFQ) queuing.
13
fe-spq <Q0-Q7> Sets the switch to use WFQ to
service all queues for the
Ethernet port.
13
Table 81 Command Summary: Configuration Mode (continued)
COMMAND DESCRIPTION P
Table 82 interface port-channel Commands
COMMAND DESCRIPTION P
interface port-
channel <port-
list>
Enables a port or a list of ports for
configuration.
13
bandwidth-
limit
Enables bandwidth control on the
port(s).
13
cir <Kbps> Sets the guaranteed bandwidth
allowed for incoming traffic on the
port(s).
13
egress <Kbps> Sets the maximum bandwidth allowed
for outgoing traffic on the port(s).
13
pir <Kbps> Sets the maximum bandwidth allowed
for incoming traffic on the port(s).
13
bpdu-control
<peer|tunnel|
discard|netwo
rk>
Sets how Bridge Protocol Data Units
(BPDUs) are used in STP port states.
13
broadcast-
limit
Enables broadcast storm control limit
on the switch.
13
<pkt/s> Sets how many broadcast packets the
interface receives per second.
13
cable_diagnos
tics
Displays whether a cable is connected
to the port (good) or not (open).
13
diffserv Enables DiffServ settings on the
port(s).
13
dlf-limit Enables the Destination Lookup
Failure (DLF) limit.
13
<pkt/s> Sets the interface DLF limit in packets
per second (pps).
13
egress set
<port-list>
Sets the outgoing traffic port list for a
port-based VLAN.
13