ADCP-75-210 • Issue 1 • March 2007
Page 55
© 2007, ADC Telecommunications, Inc.
• Three nuts, three flat washers, three 3 in. square curved washers, and three split ring
washers for bolts
Materials Required, ADC Supplied:
• RAN fixturing angle P/N 1001509P001 (X2)
• 1/4-20 X 3/4 hex bolts (X4)
• 2 in. through hull bulkhead fitting
• Flexible grommet
Use the following procedure to install an expansion RAN. Refer to Figure 39.
1. Open the existing RAN door.
2. Remove the solar shield from the existing RAN. Refer to the solar shield installation
procedure in Section 2.7.1 on Page 43 and do the steps in a reverse order.
Figure 39. Dual RAN Pole Mount
Note: This procedure assumes that the expansion RAN is installed on a utility pole
directly above the existing RAN.
21296-A
1.50 IN.
(3.8 CM)
2 IN. (5.08 CM)
BULKHEAD FITTING
SUPPLIED WITH
EXTENSION RAN
KENNARD
FLEXIBLE GROMMET
SUPPLIED WITH
EXTENSION RAN
