Uninterruptible Power Supply Crestron CEN-UPS1250
“DO RUNTIME CAL” Screen
DO RUNTIME CAL:NO
PRESS TO CHANGE
DISPLAY-BEEP TEST setting – This function allows you to force the unit to
perform display and beep tests. Simply press either the up or down arrow button.
This will cause all the indicators and display fields to illuminate, as shown in the
illustration on the following page) and an audible beep to sound.
“DISPLAY-BEEP TEST” Screen
DISPLAY-BEEP TEST:NO
PRESS TO CHANGE
Display-Beep Testing Screen
SCREEN SAVER setting – This function allows you to force the unit to
continuously alternate the message CEN-UPS POWER CONDITIONER WITH
BATTERY BACKUP between the two lines of fields on the display. This feature
helps maintain display quality as well as extending the life of the display.
NOTE: Even when the screen saver is set to ON, the screen saver message will only
display when the system load is less than 5%.
“SCREEN SAVER” Screen
SCREEN SAVER:ON
PRESS TO CHANGE
RESET TO DEFAULT setting – This function allows you to force the unit to reset
all previous settings to the factory default values. Simply press either the up or down
arrow button. The system will display two messages: INITIALIZING SETUP TO
FACTORY DEFAULT and INITIALIZATION COMPLETE. The system then
returns to the RESET TO DEFAULT screen.
NOTE: The screen illustrations in this section show default values.
“RESET TO DEFAULT” Screen
RESET TO DEFAULT:NO
PRESS TO CHANGE
30 • Uninterruptible Power Supply: CEN-UPS1250 Operations & Installation Guide – DOC. 6635A
