Programmer’s Guide, cont’d
CrossPoint 450 Plus and MAV Plus Switchers • Programmer’s Guide4-14
Command/response table for SIS commands (Cont’d)
Command ASCII Command Response Additional description
(host to switcher) (switcher to host)
View ties, gain, volume, mutes, presets, and DSVP
View RGBHV output tie
X
&
X
Example: 15& 27 Input 27 RGBHV tied to output
15.
View video output tie
X
%
X
Example:7%02Input 2 video tied to output 7.
View audio output tie
X
$
X
Example:3$06Input 6 audio tied to output 3.
View input gain
X
G
X
Example: 4G -02 Gain for input #4 is -2 dB.
View output volume
X
V
X
Example:7V55Volume for output #7 is 55 steps
(9 dB of attenuation / 86.5% of
total volume).
View output mutes
Esc
VM Mut
X14
1
2
...
X14
n
Each
X14
response is the mute
status of an output, starting from
output 1, n is the maximum
number of outputs for this
model.
Example:
Esc
VM Mut00001000000230000000000000000000
(CrossPoint 450 Plus 3232 HVA)
Output 5 video is muted, output
12 audio is muted, and output 13
video and audio are muted. All
other outputs are unmuted.
The MUT portion of the response appears only when the switcher is in Verbose mode 3. See the
Verbose mode command on page 4-19.
View video global preset configuration
Esc
X11
*
X
*1VC
X
1
•
2
•
X
3
•...•
X
16
•Vid
Show preset
X11
’s video
configuration. Show the video
input tied to 16 sequential
outputs, starting from output
X
.
Command description: preset#*starting output# (StO#)*1(=video)VC
Response description: input # (I#) assigned to StO#•I# assigned to StO#+1...I# assigned to StO#+15•Vid
Example:
Esc
4*17*1VC
17Output:
Response = tied input:
input 24 tied to output 19
18 19 20 21 22 23 24 25 26 27 28
08•08•24•08•08•29•29•00•08•01•01•01•08•08•08•08•Vid
29 30 31 32
no tied input input 8 tied to output 29
The starting output # (StO#) should always be 1 for matrix sizes of 16 outputs or smaller.
Esc
X11
*
X
*1VC where
X11
= 0 returns the switcher’s current video configuration.
Each position shown in the response is an output: left = starting, right= starting output +15. The number in each position
is the input tied to that output.
Video — Input 1 is tied to outputs 26 through 28; input 8 to outputs 17, 18, 20,21, 25, and 29 through 32; input 24 to output
19; and input 29 to outputs 22 and 23. No input is tied to output 24.
