iVIEW-100 Series user’s Manual, 2006, v2.0 ----- 168
int ToCom_2(int data);
int IsTxBufEmpty_2(void);
int WaitTransmitOver_2(void);
int ReadComn_2(unsigned char *buf,int no);
int printCom_2(char *fmt,...);
int DataSizeInCom_DMA_2(void);
int ReadComn_DMA_2(unsigned char *buf,int maxsize);
int InstallCom_DMA_2(unsigned long baud, int data, int parity,int stop);
int ClearCom_DMA_2(void);
int IsCom_DMA_2(void);
int DataSizeInCom_DMA_2(void);
int ReadCom_DMA_2(void);
void SetBreakMode_2(int mode);
void SendBreak_2(unsigned TimeMs);
int IsDetectBreak_2(void);
void SetComPortBufferSize_2(int in_size,int out_size);
/*
For Send command to I-7000/I-87K series.
*/
extern char hex_to_ascii[16];
int ascii_to_hex(char ascii);
int SendCmdTo7000(int iPort, unsigned char *cCmd, int iChksum);
/*
(INPUT)iPort:can be 0,1,3,4.
(INPUT)lTimeout: unit is ms.
(INPUT) cCmd: cmd for send to COM port(I-7000/I-87K).
DON'T add '\r' at the end of cCmd, SendCmdTo7000() will add check sum(if needed) & '\r'
after cCmd .
(INPUT) iChksum: 0: disable, 1: enable.
*/
int ReceiveResponseFrom7000(int iPort, unsigned char *cCmd, long lTimeout, int iChksum);
/*
(INPUT)iPort:can be 0,1,3,4.
