A SERVICE OF

logo

iVIEW-100 Series user’s Manual, 2006, v2.0 ----- 97
7.3 Using COM1 as a COM Port
The user can use COM1 as a general purpose RS-232 port as follows:
Download user’s program & autoexec.bat to iVIEW-100 first.
Power off iVIEW-100 & remove the download cable from PC.
Disconnect the INIT*-pin from GND-pin of iVIEW-100 if they are connected
Power on iVIEW-100 (no standard input, no standard output, no debug
information)
Install the download cable between new RS-232 device & COM1 of iVIEW-
100
Initializes the COM1 to new configuration.
The COM1 of iVIEW-100 is now a general purpose RS-232 port.