iVIEW-100 Series user’s Manual, 2006, v2.0 ----- 58
4.3 Typical commands of MiniOS7
Command Description
USE NVRAM
The service routine for read/write NVARM.
USE EEPROM
The service routine of read/write EEPROM.
USE Flash
The service routine of read/write Flash-ROM.
USE COM2 /option
The service routine of send/receive to/from COM2 (RS-485).
DATE mm/dd/yyyy]
Sets the date of RTC.
TIME [hh:mm:ss]
Sets the time of RTC.
MCB
Tests current memory block.
UPLOAD
The first step to update the MiniOs7.
BIOS1
The last step to update the MiniOs7.
LOAD
Downloads the user program into the Flash-Memory.
DIR [/crc]
Shows the information of all files download in the Flash-
Memory.
RUN [fileno]
Runs the file with file-number=fileno, no filenethe last file.
Name
Runs the file with file-name=name.
DELETE (or DEL)
Deletes all files stored in the Flash-Memory. It will delete all
files.
RESET
Resets the CPU.
DIAG [option]
Hardware Diagnostic.
BAUD baudrate
Sets the new value of communication-baudrate to baudrate.
TYPE filename [/b]
Lists content of the file.
REP [/#] command
Repeats executing the same command # times.
RESERVE [n]
Reserves n Flash Memory sectors for USER's programs.
LOADR
Downloads a file into SRAM.
RUNR [param1
[param2...]]
Runs a program saved into SRAM (downloaded by command
LOADR).
I/INP/IW/INPW port
Reads data from the hardware PORT.
O/OUTP/OW/OUTP
W port value
Outputs to hardware PORT.
… more …
… more …
Note: Refer to companion CD 8000CD\Napdos\7188e\MiniOS7\doc\index.html
for more information about MiniOS7. The MiniOS7 is also designed for 7188
/7188X/7188E/8000 family, so you will find some additional information unrelated
to iVIEW-100.
