7
Wireless Blu-ray Disc Player
www.insigniaproducts.com
Using a wired network provides the best
performance, because the attached devices
connect directly to the network and are not
subject to radio frequency interference.
2 Press ENTER. The Settings menu opens.
3 Press or to select Network, then press
ENTER.
4 Press or to select Wired, then press ENTER.
The IP Settings screen opens. If the network
connection is active, Link Up appears next to
Link Status. If the network connection is not
active, Link Down appears next to Link Status.
5 Press to go to the previous menu.
6 Press ENTER. The Settings menu opens.
7 Press or to select Network, then press
ENTER.
8 Press or to select Wired, then press ENTER.
The IP Settings screen opens.
9 Press or to select IP Mode, then press
ENTER.
10 Press or to select an IP mode. You can
select:
• Dynamic—Uses DHCP to automatically
obtain an IP address.
• Manual—Lets you manually configure
network settings, such as IP address, subnet
mask, and gateway settings. If you select
Manual, the following screen opens. Enter the
IP information here.
• Off—Disables the network interface.
11 Press to go to the previous menu.
To make changes to your network connection,
see “Changing the Network settings” on page
19.
Notes
• When plugging or unplugging the LAN cable,
hold the plug portion of the cable. When
unplugging, do not pull on the LAN cable but
unplug while pressing down on the lock.
• Do not connect a modular phone cable to the
LAN port.
• Since there are various connection
configurations, follow the specifications of your
telecommunication carrier or Internet service
provider.
IP Settings
Link Status
MAC Address
IP Mode
IP Address
Subnet Mask
Gateway
Primary DNS
Secondary DNS
Link Down
00:22:84:04:96:f1
Dynamic
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
Apply
Cancel
IP Settings
Link Status
MAC Address
IP Mode
IP Address
Subnet Mask
Gateway
Primary DNS
Secondary DNS
Link Down
00:22:84:04:96:f1
Dynamic
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
0.0.0.0
Apply
Cancel
Please enter new IP Address
Valid range of each segment is 0 to 255
Current value 111.11.11.11
New Value
OK Cancel
NS-WBRDVD2-WBRDVD2-CA_10-0745_MAN_V4.book Page 7 Thursday, July 8, 2010 3:04 PM
