20
NS-WBRDVD2/NS-WBRDVD2-CA Wireless Blu-ray Disc Player
www.insigniaproducts.com
5 Press or to select an IP mode. You can
select:
• Dynamic—Uses DHCP to automatically
obtain an IP address.
• Manual—Lets you manually configure
network settings, such as IP address, subnet
mask, and gateway settings. If you select
Manual, the following screen opens. Enter the
IP information here.
• Off—Disables the network interface.
6 Press to go to the previous menu.
Configuring a wireless Internet connection
To configure the wireless Internet connection:
1 Press ENTER. The Settings menu opens.
2 Press or to select Network, then press
ENTER.
3 Press or to select Wireless, then press
ENTER. The Wireless Settings screen opens.
4 Press or to select Network List, then press
ENTER. The Network List screen opens, showing
a list of available wireless networks.
5 Press or to select the wireless network you
want your player to connect to. A Network Setup
screen opens with the following options:
• Connect—Connect to this network.
• Disconnect—Disconnect from this network.
• Delete—Delete the current network.
• WPS Pin—Create a random PIN number
password.
6 If your network does not use encryption, press
or to select Connect, then press ENTER. If
the wireless network is working, you should see
a checkmark and a connected message on the
TV. If the message does not appear, repeat the
steps above.
OR
If your network uses encryption:
1 Press or to select the Password field, then
press ENTER. An on-screen keyboard opens.
2 Press or to select the first letter in the
password, then press ENTER. Repeat this step to
enter the rest of the password. If you make a
mistake, use backspace key to delete the
character.
3 After you enter the password, select the circled
X in the upper right-hand corner of the
keyboard, then press ENTER to close the
keyboard.
4 Press or to select Connect, then press
ENTER. If the wireless network is working, you
should see a checkmark and a connected
message on the TV. If the message does not
appear, repeat the steps above.
Setting up WiFi protection (WPS)
To set up WiFi protection (WPS):
1 Press ENTER. The Settings menu opens.
2 Press or to select Network, then press
ENTER.
3 Press or to select Wireless, then press
ENTER. The Wireless Settings screen opens.
4 Press or to select Settings, then press
ENTER. The Settings menu opens.
5 Press or to select Network.
Please enter new IP Address
Valid range of each segment is 0 to 255
Current value 111.11.11.11
New Value
OK Cancel
NS-WBRDVD2-WBRDVD2-CA_10-0745_MAN_V4.book Page 20 Thursday, July 8, 2010 3:04 PM
