107 106
Setting the Margins
To set margins, choose Page Setup from the
main File menu and enter margin settings in the
Margins tab. You can only get to Page Setup from
the Print Preview of your form. [Margins can also
be changed following the steps in the section
MASTERFORM Setup.]
If you are using the tractor form:
Because every printer is different and every form
may be fed into the printer differently, there are
no standard margin settings. You will have to
experiment to find the correct margins. As a
general rule, however, the bottom and right
margins for MASTERFORM should be left at zero.
You will probably only need to adjust the top and
left margins.
If you are using the new laser form:
We recommend the following margin settings, but
you may have to adjust slightly depending on your
printer:
Top: 0.30"
Bottom: 0.20"
Left: 0.25"
Right: 0.25"
[These suggested margin settings were configured
for HP Laser Jet 6P/6MP-Standard laser printer
drivers. Other drivers may work; this is just a
suggestion to help you set up your printer.]
4. Press the Pitch button once. The setup menu
will print the Epson Emulation option.
5. Press Start/Stop repeatedly until the ALT
light stops blinking.
You want to keep this menu setting with the
Emulation set to Epson Mode. If you go through
these steps and still get symbols when you print,
perform the steps again being very careful to
press the Start/Stop button repeatedly until the
ALT light stops blinking (up to three times; the
printer will print menu options after each time you
hit the button).
To change the Emulation Mode on an Okidata
320/321:
1. Press SHIFT + SEL at the same time to enter
the setup menu.
2. Press LF. The following line will print:
Printer Control Emulation Mode IMB PPR
3. Press TEAR repeatedly until the emulation you
want to select prints in the right-hand column.
4. Press SHIFT + SEL to save this setting and
exit the setup menu.
