266 SANRAD V-Switch User Manual
Press Enter to enter the IP mask and return to the main V-Switch
Status screen.
V-Switch 3000
Status: OK
STEP 5. L
OGIN TO THE MANAGEMENT PORT
From your management terminal, open a Telnet session with the management
port.
From the Windows Start menu, select Run.
In the Open window, enter:
telnet 100.100.100.2
Click OK. A Telnet session window opens.
Press Enter on your keyboard to open the V-Switch 3000 Login window.
Figure 107. V-Switch 3000 Login Screen
Enter the default user name and password and press Enter on your
keyboard. The CLI prompt > appears. You are now logged in and
ready to begin configuring your V-Switch for volume virtualization and
exposure.
STEP 6. CONFIGURE NETWORK PORT ETH 2 IP ADDRESS
Use the CLI command ip config set to configure the network port Eth 2
for communications between the V-Switch and host stations.
ip config set –if eth2 –ip 212.199.43.56 –im
255.255.255.0 –act 1
STEP 7. C
ONFIGURE ISCSI PORTAL
The port number you
set in the CLI must
coincide with the port
number you set in
your iSCSI initiator
configuration.
Use the CLI command iscsi portal create to configure the iSCSI
portal on network port Eth 1 for iSCSI communications between the V-Switch
and the host station.
iscsi portal create –ip 212.199.43.56 –p 5003
STEP 8. C
ONFIGURE IP ROUTING PATH
