Filter
Top Products
Gateway Installation and Support Guide
17
Appendix E: Back-Up Key Codes
In most cases, you will receive a key code from your ISP. This key code is used to activate the 2Wire
gateway. If you did not receive a key code, you can use the key codes provided in the following table.
If your Internet Service Provider did not provide you with
a user name, password, or IP address to set up your
Internet connection, your broadband connection most
likely uses DHCP (Dynamic Host Configuration Protocol)
and you should use this key code.
52EU-2374-2262-22AT-B222
If your Internet Service Provider gave you a PPPoE
username and password to set up your Internet
connection, your broadband connection uses Point-to-
Point Protocol over Ethernet and you should use this key
code.
52EU-2374-6262-22AS-B22Y
If your Internet Service Provider assigned you an IP
address to set up your Internet connection, your
broadband connection uses static IP (Internet Protocol)
and you should use this key code.
52EU-2374-2E66-22AS-B2TW
If your Internet Service Provider gave you a PPPoA
username and password to set up your Internet
connection, your broadband connection uses Point-to-
Point Protocol over ATM. In this case, you would use this
key code and Microsoft Dial-up Networking to connect to
the Internet.
52EU-2374-A222-22AS-B2QK