Filter
Top Products
Configuring Mulitple Static IP Addresses
69
If you did not receive a subnet mask from your ISP, but were provided with a number of addresses has been,
you can look up the associated subnet mask in the table below. Because this information may have been
identified in a number of different ways, it has been presented here in a number of different ways.
Step 2: Allocate Public IP Addresses to the LAN Clients
This step requires that all network devices that you wish to configure with a broadband IP address be turned
on and connected to the 3700HGV-B. Devices should be configured to use their DHCP client for obtaining
an IP address, although this is not an absolute requirement as identified below.
Once the gateway is configured to use multiple broadband IP addresses, network devices can be configured
for one of three modes. Access the Address Allocation page of the MDC to select the desired option (Figure
2) for each LAN device. This information can also be set by clicking the
EDIT ADDRESS ALLOCATION button on
the Home Network - Advanced Settings page.
• Mode 1: DHCP Private Network. The network client is given a private IP address on the private network
(Default is the 192.168.1.0 network). This is the normal mode of operation for all LAN devices by
default (with or without the use of multiple broadband addresses.)
• Mode 2: Public Fixed Network. The network client is given one of the currently available broadband IP
addresses. The address may change as the IP address lease is renewed, but will always come from the
pool of available broadband IP addresses.
• Mode 3: DHCP Fixed Address. The network client is permanently assigned one of the broadband IP
addresess. The address will not change until the gateway is reconfigured via the Address Allocation
page. This will be the most common configuration for publicly accessible network devices.
In all the above cases, the network devices should be configured to enable their DHCP client. From this
point on, the IP addresses for these LAN devices are managed by the 3700HGV-B. However, if DHCP is
unavailable or its use undesirable, devices can be configured (hard-coded) with a static IP address.
For devices in the Private Network (NAT), the proper range must be used. The default range is 192.168.1.0,
so the network device may statically use 192.168.1.1 through 192.168.1.64, inclusive. Devices assigned
with these addresses act as if they were assigned an IP address (Mode 1 above).
Total
Address
Used by the
Subnet CIDR
Number of
Useable
Addresses
Address
Required for
DSL Router
Addresses
Available for
LAN
Devices Subnet Mask to Use
8 /29 6 1 5 255.255.255.248
16 /28 14 1 13 255.255.255.240
32 /27 30 1 29 255.255.255.224
64 /26 62 1 61 255.255.255.192
128 /25 126 1 125 255.255.255.128
256 /24 254 1 253 255.255.255.0