Filter
Top Products
Connect the Computer to the Gateway
7
Wireless Connection
Requires wireless-enabled notebook or a computer with an 802.11b/g wireless network adapter installed.
Wireless adapters can be purchased from the service provider.
1. Connect the provided AC power adapter from the 3700HGV-B’s POWER port to an electrical outlet. After
the 3700HGV-B has completed its start up process, the
POWER light on the front of the 3700HGV-B
should be green.
2. If the VDSL signal is carried over the phone line, connect the provided gray phone cable from the
3700HGV-B's
PHONE LINE port to telephone wall jack. If the VDSL signal is carried over coax, refer to
page 11.
3. Install the wireless adapter according to the manufacturer’s instructions (see note below).
Note: If you use a 2Wire wireless adapter (PCI, PC card, or USB adapter) for wireless networking,
the 2Wire gateway Setup Wizard CD automatically configures it to communicate with the gateway
during setup. If you are NOT using a 2Wire wireless adapter, you must manually configure your
adapter to communicate with the gateway using the information on page 8.