Filter
Top Products
2
GETTING STARTED
This chapter describes the installation and setup pro-
cedures for the Switch 2000 TR:
■ Important Safety Information
■ Positioning the Switch 2000 TR
■ Installing the Slide-in Modules
■ Installing the Switch 2000 TR
■ Connecting Redundant Power System
■ Connecting to the Serial Port
■ Device Defaults
Important Safety Information
NOTE: Warnings contain directions that you must
follow for your personal safety. Follow all instructions
carefully. Please read the following safety information
before installing the Switch 2000 TR.
■ Installation or removal of any add-in module or
cable must be performed by qualified personnel
only.
■ The Switch 2000 TR must be attached to a
grounded power source.
■ The power cord must comply with the standards of
the country in which the Switch 2000 TR is to be
installed.
■ For USA and Canada:
■ The cord must be UL-approved and CSA certi-
fied.
■ The minimum specifications for the flexible
cord:
No. 18 AWG
Type SV or SJ
3-conductor
■ The cord must have a rated current capacity of
at least 10 Amps.