3Com 2900 Switch User Manual


 
2-1
2 Installation Preparations
Safety Precautions
To avoid any device impairment and bodily injury caused by improper use, observe these rules:
z Before cleaning the switch, plug out the power cord of the switch first. Do not clean the switch with
wet cloth or liquid.
z Do not place the switch near water or in a damp environment. Prevent water or moisture from
entering the switch chassis.
z Do not place the switch on an unstable case or desk. The switch might be damaged severely in
case of a fall.
z Ensure proper ventilation of the equipment room and keep the ventilation vents of the switch free of
obstruction.
z Connect the yellow-green protection PGND cable before power-on.
z Make sure that the operating voltage is in the range labeled on the power of the switch.
z Do not open the chassis to avoid electrical shocks when the switch is operating or just when the
switch is powered off.
Installation Site
The 3Com Baseline Switch 2900 Family must be used indoors. You can mount the switch in a rack or on
a workbench, but make sure:
z Adequate clearance is reserved at the air inlet/exhaust vents for ventilation.
z The rack or workbench has a good ventilation system.
z The rack is sturdy enough to support the device and its accessories.
z The rack or workbench is well earthed.
To ensure normal operation and long service life of your switch, install it in an environment that meets
the requirements described in the following subsections.
Temperature/Humidity
You must maintain a proper temperature and humidity in the equipment room. Long-term high humidity
may lead to bad insulation, electricity leakage, mechanical property changes, and metal corrosion.
However, if the relative humidity is too low, captive screws may become loose as the result of
contraction of insulation washers and static electricity may be produced in a dry environment to
jeopardize the circuits on the device. A high temperature is the most undesirable condition, because it
accelerates the aging of insulation materials and thus significantly lowers reliability and service life of
the switch.
For the temperature and humidity requirements of different models, refer to
Table 2-1 on page 2-2.
Cleanness
Dust is a hazard to the operating safety of your device. The dust accumulated on the chassis can be
adsorbed by static electricity and result in poor contact of metal connectors or metal contact points.