3Com 3C589D Network Card User Manual


 
Features
1-3
Features
Parallel Tasking
®
II architecture for greater network
speed.
Power savings (when there is no network activity, the
3C589D PC Card turns off power to itself).
Compliance with 10BASE-T and 10BASE2 standards.
Integrated Card Services support.
“Hot Swap” support (you can remove and replace the
PC Card without rebooting the PC if you have Card
Services installed).
Driver support for Microsoft
®
(NDIS) and Novell
®
NetWare
®
(ODI) networks.
Automatic PC Card configuration (AutoLink
program)
for Novell NetWare DOS ODI.
Windows
®
95 Plug and Play support.
EtherDisk
®
diskette containing the 3C589D PC Card
software, network drivers, and text files that contain
technical information about the 3C589D PC Card.
Network management capabilities using 3Com’s
Transcend
®
PC Link SmartAgent
software. (Refer to
the
3Com Transcend PC Link SmartAgent Software User
Guide
for more information.)
Requirements
Make sure your PC meets the following requirements:
PC Card (PCMCIA) Type II or Type III card slot and a
3 1/2-inch diskette drive.
Windows or DOS 3.1 and higher.
80386 or higher processor.
450 K of lower memory available to run the installation
software.
Access to a network port for a network connection.
Call your MIS representative to get a network port.
The EtherDisk diskette contains a README.TXT file that
describes important information that became available
after this guide was printed.