Filter
Top Products
20 M170 FPD Monitor Installation Guide
Table 2. Supported Mag Stripe Card Readers
ID Tech® MagTek®
all MiniMag™ readers all "mini" sized
readers
IDT 3331-02U IDT 3321-33 2180201
IDT 3331-12U IDT 3321-33PP 2180202
IDT 3331-23U IDT 3331-02 2180203
IDT 3331-33U IDT 3331-12 2180204
IDT 3321-02 IDT 3331-23 2180205
IDT 3321-02PP IDT 3331-33 2180206
IDT 3321-12 IDT3301-02 21040103
IDT 3321-12PP IDT3301-12 21040104
IDT 3321-23 IDT3301-23
IDT 3321-23PP IDT3301-33
Connecting the Touch Monitor
CAUTION
You are cautioned that any change or modification to the equipment not expressly approved by
the party responsible for compliance could void your authority to operate such equipment.
The M170 comes with the cables already connected (with the exception of the audio
cable), however, there may be times when you need to reconnect these cables for some
reason. To connect the M170 FPD monitor:
1. Turn off your computer. You should always turn off the computer before connecting or
disconnecting any device.
Figure 11. Identifying Your Monitor Connections
Powe
r
Head
p
hone Line In Video Connection Touch Screen
2. Connect one end of the video cable to the video connector on the FPD. Connect the other end
to the video card in your computer.
3. Connect one end of the touch screen cable (either serial or USB) to the FPD. Connect the
other end to an available port on the back of your computer. If you are using a USB
connection, make sure you have installed the TouchWare drivers prior to connecting the
touch screen cable.
3M Touch Systems Proprietary Information