Filter
Top Products
19
3M
™
Multimedia Projector MP7760
© 3M IPC 2000
Figure 5-1. Remote control functions
Section 5: Remote Control
5-1. Remote Control Functions
Aim the remote control toward the projection screen or at the sensor. Press desired remote button to send a
signal to the projector.
Note: The buttons marked with an asterisk (*) also appear on the operator touch panel keypad.
*Standby:
Switch the projector between
Standby mode (lamp off, fan off)
and Operation mode (lamp on, fan
on).
Brightness: Decrease (-) or
increase (+) brightness of the
displayed image.
*Enter:
In mouse emulation mode:
Left mouse button (L).
Not in mouse emulation mode:
Enter button for confirmation
of a selection.
*Menu: Display system menus.
*(-/+): Decrease (-) or increase (+)
menu values or magnify factor.
Reveal:
Press Reveal to cover the
image on the screen with a
gray mask. Use the Joystick
to reveal the image. Press
Reveal again to return.
Timer: Display timer (window
in lower part of screen or full
screen). Repeated operation
of key toggles between.
Blank:
Replace projected image with
preselected background blank color.
Press again to return to image.
Mouse:
Toggle mouse emulation On/Off.
On: The L & R buttons operate.
Off: L button is the Enter confirma-
tion button. R button is for menu
window positioning. Disc Pad
Centers the image.
Mute:
Toggle On/Off the audio sound.
PC:
Switch displayed image to PC/RGB input.
*Volume: Decrease (-) or increase (+)
speaker volume.
Video:
Switch displayed image to video input.
In Video mode toggles between:
Video / SVHS / AUX
*Joystick (mouse pointer):
Move (point) the cursor on the projected
image. (See Pointer.) Navigate menus.
*Menu window position:
In mouse emulation mode:
Right mouse button (R).
Not in mouse emulation mode:
Keep button pressed while moving
menu window around with the
Joystick.
Optimize:
Adjust brightness and contrast for best
picture.
Freeze: Stores (freezes) the projected
image. Press again to return to the
projection of the current image.
Pointer:
Places a pointing device on the screen.
Use Joystick to move pointer.
Press again to turn pointer off.
Magnify: Press to enable magnification
mode. Press -/+ buttons to decrease/
increase the magnification factor. Move
Joystick to displace the magnified area
within the image. Press Magnify again to
toggle back to normal presentation.
In video mode (NTSC only), press Magnify
to toggle between scaled and unscaled
representation.
Mode 1, 2, 3, 4:
Toggle between remote control
addresses 1, 2, 3, 4. (See
Appendix A-3.)