3M MP7760 Projector User Manual


 
3M
Multimedia Projector MP7760
4
© 3M IPC 2000
Introduction
WARNING
Caution
Caution
Intended Use
Before operating the machine, please read the entire manual thoroughly. The 3M Multimedia Projector MP7760 was
designed, built, and tested for use indoors, using 3M lamps and nominal local voltages. The use of other replacement
lamps, outdoor operation, operation in environments containing heavy cigarette smoke or different voltages has not been
tested and could damage the projector or peripheral equipment and/or create potentially unsafe operationg conditions.
Important Safeguards
1. Read and understand all instructions before using. Pay particular attention to areas where these symbols are shown:
Indicates a potentially hazardous situation which,
if not avoided, could result in death or serious injury.
Indicates a potentially hazardous situation which, if not
avoided, could result in minor or moderate injury. It may
also be used to alert against unsafe practices.
Note - Used to emphasis important conditions or details.
2. Close supervision is necessary when any appliance is used by or near children. Do not leave appliance unattended
while in use.
3. Never look directly into the projector lens when the lamp is on. The high pressure mercury lamp produces a strong
light that could damage your eyesight.
4. Care must be taken, as burns can occur from touching hot parts.
5. Do not operate appliance with a damaged cord or if the appliance has been
dropped or damaged - until it has been examined by a qualified service technician.
6. Position the cord so that it will not be tripped over, pulled or placed in contact with hot surfaces.
7. If an extension cord is necessary, a cord with a current rating at least equal to that of the appliance should be used.
Cords rated for less amperage than the appliance may overheat.
8. Always unplug appliance from electrical outlet before cleaning and servicing and when not in use. Grasp plug and
pull to disconnect.
9. To reduce the risk of electric shock, do not immerse this appliance in water or other liquids.
10. To reduce the risk of electric shock, do not disassemble this appliance. Take it to a qualified technician when
service or repair work is required. Incorrect reassembly can cause electric shock when the appliance is subse-
quently used.
11. The use of an accessory attachment not recommended by the manufacturer may cause fire, electric shock, or injury.
12. Connect this appliance to a grounded outlet.
13. This unit is equipped with optical lenses and should not be exposed to direct sunlight..
14. Keep ventilation openings free of any obstructions.
15. Always operate machine on a flat, sturdy surface.
16. The projection lamp contains mercury. Always dispose of it in a proper manner according to local
regulations.
17. To avoid deposits forming on internal components, do not operate projector in extremely humid environments
(RH > 80%) or near any type of fine mist.