Filter
Top Products
64 8e6 enterprise reporter Quick start Guide64 8e6 enterprise reporter Quick start Guide
appendix: san installation
D. Plug the other end of the CAT-5E crossover cable into the storage device’s port “0”
(zero) on the right (see Figure 3 Item B).
E. Plug the storage device’s AC power cords into the back of the unit (see Figure 3 Item
C).
F. Plug the loose ends of the AC power cords into a power source with an appropriate
rating. It is strongly suggested you use an uninterruptible power supply.
WARNING: Be sure all drives are installed in the storage device unit before
powering on the unit. Be sure the ER unit is not powered on.
G. Turn on the power switches at the back of the storage device,
which are positioned to the right of the power cord connectors.
The boot-up process may take up to 5 minutes. When the unit
is booted up, the three vertical LED lights at the left of the front
panel will be lit up (see Figure 4).
Once all LED lights are lit, the ER can be powered on.
Shut Down, Restart Procedures
Follow the procedures in this section if you need to shut down or
restart the storage device.
Shut Down the Storage Device Unit
If you need to shut down the storage device, always follow these
steps:
Figure 4: LED
display
A. Power off the ER unit rst. (Refer to the Physically Connect the ER to the Network
sub-step in Step 1B of the ER section for shut down procedures.)
B. Power off the storage device next by turning off both switches in the back of the unit.
Restart the Storage Device Unit
The storage device must be restarted after a power failure. In this instance, the storage
device may already be turned on, but needs to be booted up again.
WARNING: You must always power on the storage device before powering on
the ER unit. Since the storage device is an information database, if you experience
a power interruption or if you power off the storage device without going through
the standard shut down procedures, you may lose data and/or damage the le
system.
To restart the storage device, press the power button on the front panel. The boot-up
process may take up to 5 minutes.