Filter
Top Products
Fast SwitcHub-2se User’s Guide
iv Quick Installation
5. Set the transmission mode for each port to full or half-duplex. Full-duplex
communications can only be supported for a dedicated link (i.e., set the
communications to half duplex if you are connecting to a shared collision
domain). Transmission must be set to full duplex or half duplex depending
on the mode supported by the connected device. You must manually set the
required mode with the configure button (Chapter 2).
6. Verify network communications by ensuring that -
• you have made all the necessary connections
• you can access any connected resources
• the switch’s indicator LEDs are functioning properly
Note: For devices connected directly to either port on the switch, it will
automatically detect transmission speed (10/100 Mbps). However, unless
the connected devices are operating at half-duplex (i.e., system default), you
will have to manually set the transmission mode via the configure button.
(Refer to Full/Half Duplex Mode Selection in Chapter 2).
If you encounter any problems in installing the Fast SwitcHub-2se, refer to Chapter
2 for a detailed description of installation procedures, or to Appendix A for help
in troubleshooting.