Filter
Top Products
Basic Configuration
3-17
3
If you download to a new destination file, then select the file from the drop-down box
for the operation code used at startup, and click Apply Changes. To start the new
firmware, reboot the system via the System/Reset menu.
Figure 3-9. Setting the Startup Code
CLI – Enter the IP address of the TFTP server, select “config” or “opcode” file type,
then enter the source and destination file names, set the new file to start up the
system, and then restart the switch.
Saving or Restoring Configuration Settings
You can upload/download configuration settings to/from a TFTP server. The
configuration file can be later downloaded to restore the switch’s settings.
Command Attributes
• TFTP Server IP Address – The IP address of a TFTP server.
•
File Name
— The configuration file name should not contain slashes (\ or /),
the
leading letter of the file name should not be a period (.), and the maximum length
for file names on the TFTP server is 127 characters or 31 characters for files on
the switch. (Valid characters: A-Z, a-z, 0-9, “.”, “-”, “_”)
Note:
The maximum number of user-defined configuration files is limited only by
available flash memory space.
Console#copy tftp file 4-63
TFTP server ip address: 10.1.0.19
Choose file type:
1. config: 2. opcode: <1-2>: 2
Source file name: M100000.bix
Destination file name: V1.0
\Write to FLASH Programming.
-Write to FLASH finish.
Success.
Console#config
Console(config)#boot system opcode:V1.0 4-67
Console(config)#exit
Console#reload 4-22