Filter
Top Products
7-15 User Guide for AIR-104/AIR-204
Example
:
Command> change password
Please enter the old password: ********
Please enter the new password: ********
Please re-enter the new password: ********
Password has been successfully changed
clear config
Description:
This command is used to clear the configuration data in the flash memory.
After clearing, the system will reboot. All user-configured data are lost. The configuration
will return to the factory default settings.
disable/enable remote-mgt
Description:
This command allows the administrator to lock out or enable both browser
and telnet management connections. Only a direct console connection is supported if
remote management is disabled.
download config <filename> from <ipaddr>
Description:
This command causes the configuration file
<fileName>
to be downloaded
to the system from a tftp server with the specified IP address.
Example:
Command> download config ar104.cfg from 205.51.23.12
download firmware
Description
: This command causes the product firmware to be downloaded to the
system from a directly attached PC running the terminal emulation software (one with z-
modem file download capability). Note that this command cannot be used from a telnet
session. This is an alternative to downloading the software using the Internet
Configuration Console browser utility.
Since the router will reset after this operation is complete, the system will first prompt for
the confirmation. The system will ask the user to select the download speed. The user
may then change the terminal baud rate for a faster download and press enter to
continue (some terminal emulators require a disconnect followed by a connect in order
for the changed parameters to take effect). Select the Z-modem protocol for use in
downloading the firmware. The user then selects (opens) the firmware file for actual
downloading.
Upon completion of the download, the router will reset and is therefore intrusive to any
active Internet session.
help
(This list may differ depending upon the AIR-104/204 model):
Example:
Command> help
Commands are categorized as follows:
(1) Diagnostics (2) IP (3) Port
(4) Profile (5) Security (6) Statistics
(7) System
Chapter 7 Command Line Interface