Filter
Top Products
7-19 User Guide for AIR-104/AIR-204
Show system log
Description:
The system log contains logs of various events of interest, depending on the
log level set at the time. Common events include login, an Internet connection goes up or
down (log level 2), … as well as certain protocol progress messages for debugging
purposes.
This command shows the next 22 entries of the system log. For example, if there are 60
entries in the log, the first show system log command will show log entries 1 through 23,
the next command will show entries 24 through 46, and the next command will show
entries 47 through 60, followed by 1 through 9. When the system powers up, the log is
re-initialized and contains no entries. As time passes, when the 128-entry log table
becomes full, new entries will simply replace the oldest entries, thus a first-in, first-out
scheme is used.
Example:
AcerRouter> show system log
1 12/13/99 20:38:20 Modem: port 1 start to autobaud
2 12/13/99 20:38:20 Modem: port 2 start to autobaud
3 12/13/99 20:38:20 IP RIP: Set IP rip mode to: 0x3
4 12/13/99 20:38:20 Modem: port 1 autobaud successfully
5 12/13/99 20:38:21 Modem: port 1 has been initialized
6 12/13/99 20:38:22 Modem: port 2 autobaud successfully
7 12/13/99 20:38:23 Modem: port 2 has been initialized
8 12/13/99 20:38:42 Console Port: login from tty0 (telnet)
9 12/13/99 20:40:02 Modem: port 1 dial
10 12/13/99 20:40:35 KERNEL: modem link is up
11 12/13/99 20:40:35 ASYNPPP: Event 6, ppp3073 input:
12 12/13/99 20:40:35 ASYNPPP: Event 6, 42 49 53 0d 0a
13 12/13/99 20:40:35 PPP: PPP Link Up: isp1
show telnet session
Description:
This command is used to display all existing telnet sessions.
Example:
AcerRouter> show telnet session
Session Id Remote Ip Remote Port
------------------------------------------------------------------------------------------------------------
1 192.168.168.120 1221
show time
Description:
This command shows the time zone, daylight savings time setting, date and
time of the day. For AIR-104/204 systems, the time is only correct after an HTTP session
has accessed this system or the time has been manually set using the set time
command.
Example:
AcerRouter> show time
Time (GMT-8) (Standard Time) : Mon Dec 06 17:07:21 1999
upload config <filename> to <ipaddr>
Description:
This command causes the system configuration to be uploaded to
the specified tftp server (whose IP address is 205.51.23.12)
as a file called <fileName>.
Example:
Command> upload config ar204.cfg to 205.51.23.1
Chapter 7 Command Line Interface