Filter
Top Products
36
EDID Upgrade SOP
Equipment List
1. PC : with parallel (printer) port
2. EDID Board
3. Printer cable : 25pin male-female (connect PC to EDID board)
4. D-sub cable* : with full 15pin (connect EDID board to Projector)
5. HDMI cable*(connect EDID board to Projector)
6. DVI cable* (connect EDID board to Projector)
(*Note: Not every model’s EDID input (D-sub, DVI, HDMI) is the same. Need to check what
kind of file you need before download.)
Setup Equipment
1. Let projector be in Full-power standby mode (Press “Power” and “Source” and plug in
power cord into Projector immediately.)
2. Connect between PC, EDID board and the Projector:
3. Need to set Jumper before using EDID board :
<Jumper setting :>
J6 : 1,2 short
J8 : 1,2 short
J10 : short
Link to Main
board :
For D-sub DDC
download
Link to Projector :
For HDMI DDC
download
(no need in
X1130/ X1230/ X1230S/
X1235/ X1230K series)
Link to Projector :
For
DVI-D DDC download
(no need in X1130/ X1230/
X1230S/ X1235/ X1230K
series)
“25pin male-female
cable” (normal
printer cable)
EDID board
PC with parallel
(printer) port
Please ignore this
connector