Filter
Top Products
93
Setting the Boot Drive Sequence
The Boot Drive Sequence section lists boot priorities (1st, 2nd and 3rd) for
bootable drives in your computer.
For example, the default value (1st:Floppy Disk, 2nd:Hard Disk, and 3rd:CD-
ROM) tells the computer to first search for a bootable floppy disk in the floppy
drive. If it finds one present, it boots up from that floppy disk. If not, the computer
continues by booting up from the hard disk. If it cannot boot up from the hard
disk, it continues to search for a bootable CD-ROM in the CD-ROM drive.
To set the boot drive sequence, use the cursor up/down keys to select a priority
level (1st, 2nd, or 3rd); then use the cursor left/right keys to select the device for
that priority level.
Onboard Devices Configuration
The parameters in this screen are for advanced users only. You do not need to
change the values in this screen because these values are already optimized.
Hotkey Beep Enables or disables a system beep when a
hotkey or key combination is pressed.
Enabled
or
Disabled
Fast Boot Fast Boot allows your computer to boot up
and resume from Sleep mode (including
Standby and Hibernation modes) faster.
When enabled, the operating system and
BIOS communicate information about Plug-
and-Play resources and previous boot-ups.
Enabled
or
Disabled
Boot Drive
Sequence
Specifies the order in which the computer
starts up from. See the section below.
1st: Floppy Disk,
2nd: Hard Disk,
3rd: CD-ROM
Parameter Description Options