Filter
Top Products
Chapter 2 30
IDE Channel 1 Slave Lets you configure the hard disk drive connected to the
slave port of IDE channel 1.
To enter the IDE Channel 1 Slave setup, press
e.
The IDE CD-ROM is always automatically detected.
(Show the Status:)
None
HDD or CD-ROM Number
Drive A Allows you to configure your floppy drive A. 1.44 MB, 3.5-inch
None
360 KB, 5.25-inch
1.2 MB, 5.25-inch
720 KB, 3.5-inch
2.88 MB, 3.5-inch
Drive B Allows you to configure your floppy drive B. None
360 KB, 5.25-inch
1.2 MB, 5.25-inch
720 KB, 3.5-inch
1.44 MB, 3.5-inch
2.88 MB, 3.5-inch
Video This item specifies the type of video card in use. The
default setting is VGA/EGA. Since current PCs use
VGA only, this function is almost useless and may be
disregarded in the future.
EGA/VGA
CGA40
CGA80
MONO
Halt On This parameter enables you to control the system stops
in case of Power-on self-test (POST) errors.
All, But Keyboard
All Errors
No Errors
All, But Diskette
All, But Disk/Key
Base Memory Refers to the portion of memory that is available to
standard DOS programs. DOS systems have an
address space of 1 MB, but the top 384 KB (called high
memory) is reserved for system use. This leaves 640
KB of conventional memory. Everything above 1 MB is
either extended or expanded memory.
Extended Memory Memory above and beyond the standard 1 MB
(megabyte) of base memory that DOS supports.
Extended memory is only available in PCs with an Intel
80286 or later microprocessor. Extended memory is not
configured in any special manner and is therefore
unavailable to most DOS programs. However, MS
Windows and OS/2 can use extended memory.
Total Memory Total base, and extended memory, and I/O ROM 384KB
available to the system.
Parameter Description Options