Filter
Top Products
14628 Central Blvd,
Chino, CA91710
tel:909.597.7588, fax:909.597.1939
© Copyright 2011 Acnodes, Inc.
All rights reserved. Product description and product specifications
are subject to change without notice. For latest product information,
please visit Acnodes’ web site at www.acnodes.com.
PC 6415
15” Fanless Panel PC
4.7 HDD INSTALLATION (PC6412 AND PC6415 ONLY)
To install the HDD into the PC6412/ PC6415, please follow the steps below:
Step 1: Remove the aluminum cover.
Step 2: Remove the four HDD bracket retention screws and lift the HDD bracket off
the panel PC.
Step 3: Attach the HDD brackets to the HDD. To do this, align the four retention screw
holes in the both sides of the HDD bracket with the retention screw holes on the sides
of the HDD. Insert four retention screws into the HDD bracket (Figure 4-4).
Step 4: Connect the SATA cable to the rear of the HDD and the SATA connector on
the motherboard.
Step 5: Install the HDD into the PC6412/ PC6415 by aligning the retention screw holes
in the HDD brackets with the retention screw holes on the chassis. Insert the four reten-
tion screws.
Step 6: Replace the aluminum back cover to the chassis.
Step 7: Replace the plastic back cover.
4.8 AT/ATX MODE SELECTION
AT and ATX power modes can both be used on the PC Series-N270. The selection is
made through an AT/ATX switch on the bottom panel. To select AT mode or ATX mode,
follow the steps below.
Step 1: Locate the AT/ATX switch on the bottom panel (Figure? 2-6).
Step 2: Adjust the AT/ATX switch.