Filter
Top Products
26
Changing the Set-up of Your WLAN
7 Click Save.
Your changes are saved. You must reboot your Wireless AP to
apply your changes. Click Reboot on the Success page, or
continue working in the Wireless Access Point Utility and click
Reboot from the Administration page (see page 27) at the end of
your session. You do not have to reboot your computer.
To delete a MAC address:
1 In the Addresses to Allow box, click on the MAC address.
2 Click Remove Selected.
3 Click Save.
Your changes are saved. You must reboot your Wireless AP to
apply your changes. Click Reboot on the Success page, or
continue working in the Wireless Access Point Utility and click
Reboot from the Administration page (see page 27) at the end of
your session. You do not have to reboot your computer.
Changing the Administration Password
By default, no password is set for the Wireless Access Point Utility.
However, to increase network security and prevent unauthorized
users from accessing your Wireless AP, you should set an
Administration password.
To change the Administration password:
1 Open the Wireless Access Point Utility and log on. (See page
12.)
2 Click the Administration tab.
3 Type your new password in the top Change Password box, then
re-enter it in the box below.
4 Click Reboot. (You do not have to reboot your computer.)